For The Circuit Shown In Figure, When 𝑉 𝑠 = 0 , 𝐼 = 3 𝐴 , When 𝑉 𝑠 = 200 𝑉, What Will Be The Value Of I

 

For The Circuit Shown Below V1 Is Given By 2+0.1Sinwt Volts. Assuming Vd=0.7V And Diode As Linear Device The output Voltage V0 Is Given By

 

The Laplase Transform Of A Transportation Lag Of 5 Seconds Is

 

Three Lamps Are In Circuit As Shown In Figure. At What Condition 100 W Lamp Will Have The Maximum Brightness

 

A ‘P’ Pole, 50 Hz Alternator Is Driven By A 60 Hz Synchronous Motor. Calculate The Number Of Poles For The Synchronous Motor

 

In Designing Lighting Scheme Utilization Factor Is Used It Is Defined As

 

Define The Current Gain Alpha And Beta For A Transistor Obtain The Relation Between Them

An Eight Pole Wound Rotor Induction Motor Operating On 60Hz Supply Is Driven At 1800 Rpm By A Prime Mover In The Opposite Direction Of Revolving Magnetic Field. The Frequency Of Rotor Current Is

 

A Battery Is Charged By A Single Phase Half Wave Diode Rectifier.The Supply Voltage Is 200V(Rms) 50Hz And The Battery Emf Is Constant At 100V.If The Diode Has Voltage Drop Of 2V During Its Conduction The PIV Rating Of The Diode Should Be

 

Turn On And Turn Off Time Of Transistor Depends On

 

A Rectifier Instrument Is Used To Measure An Alternating Square Wave Of Amplitude 100V.What Is The Meter Reading?

 

A resistance R is measured by the ammeter-voltmeter method. The voltmeter reading is 200 V and its internal resistance is 2K. If the ammeter reading is found to be 2A, then value of R is

 

What is the average value of the given waveform? Take the maximum value as Vm

 

For A Two Port Reciprocal Network The Three Transmission Parameters Are A=4 B=7 And C=5 What Is The Value Of D

 

Three Conductance G1=0.5S G2=0.3S And G3=0.2S Are In Parallel.If The Total Circuit Current Is 4A Current In G1 Is

 

Calculate The Resolution Of A 3-Digit 0 - 1 V Digital Voltmeter

 

An induction machine is operated with two values of frequencies with the ratio of 1:2 without changing the voltage. Then the starting torque of the machine for two cases will be in the ratio of

 

Semiconductor strain gauges typically have much higher gauge factors than those of metallic strain gauges, primarily due to

 

What Is The Dynamic Impedance Offered By Ideal Tank Circuit In A Network

 

A Transistor is connected in ce configuration with Vcc=15v.the voltage drop across the 600 ohm resistor in the collector circuit is 0.3v.if α=0.98.The base current is